IMTS 2016: Byce Workholding Vise is made with Destiny Diamondback & Viper!

"Diamondback ran for 6 weeks and still feels sharp!"

Brent Biestel from Byce Tool, introduced his new double station vise at the IMTS 2016 show at the Doosan booth.

​We met Brent at D&L Industrial Supply's Open House this past summer and told him about the Viper's and Diamondbacks. Later we found him on Instagram (@bycetoolworkholding) and it turns then found out out he started using Destiny End Mills to make his new workholding vise!

According to Brent, he's using a 5/8" Diamondback to remove roughly 20 CIM of material every 1/2 hour and the Diamondback has been running for 6 weeks in the cut!!! ...and it's still running.  Brent is also running Viper End Mills to make the aluminum jaws.  

Brent goes on to tell us about his new vise and many new features that's he's come up with. Check out the video below more.

We're planning on visiting Brent to get more video of our tools in the future so stay tuned for more video!

The 4" Quad Station Byce Tool Vise

---

---

About the Byce Tool Workholding Vise

Reversible knuckle and 4 way jaw

• Double Station Vise.
• Available in 4" & 6" laydown and tombstone versions.
• Available as a quad station laydown version - single body, 4 stations!
• Use all 4 sides of machinable jaws.
• Large machinable area of all 3 jaws compared to anything else on the market.
• Quick Change attachments for knuckle easily replaceable.
• ID and OD clamping just by reversing the knuckle.
• Ability to use all 4 sides on the center jaw.
• Various heights of jaws available
• Lead screw completely sealed form coolant and chips
• 400 series THROUGH hardened stainless steel ways!